海船船员适任证书三管轮模拟试题3(轮机英语)
-
The number of cycles per second occurring in AC voltage is known as the _____.
- A.phase angle
- B.frequency
- C.wave form.
- D.half mode
-
When the ship, its main propulsion device equipped with clutch, arrived at the port and finished with the engine, the correct operation should be .
- A.disengaging the clutch firstly, then stopping the main engine
- B.stopping the main engine firstly, then disengaging the clutch
- C.stopping the cooling water pump firstly, then stopping the main engine
- D.stopping the main engine and disengaging the clutch at the same time
-
In using reduction gears to obtain efficient propeller speeds, _____.
- A.they must be located at the after end of the engine
- B.they can only be used with one engine at a time
- C.they eliminate the need for controllable pitch propellers
- D.they are connected to the engine with a flexible coupling
-
The feed water to the boiler will comprise _____.
- A.condensate
- B.a small amount of make-up feed
- C.A and B
- D.None of the above
-
Why is it important for fuel oil tanks not to be topped off at the inner bottom level when loading on a cold day?
- A.Increased viscosity of the product needs higher loading pressure, which increases the chances of a spill
- B.Air pockets may cause the fuel to bubble out of the ullage hole
- C.The temperature rise of the fuel will cause an overflow
- D.Fueling valve may become stuck closed and cause the fuel oil to spill before the valve can be opened
-
Which of the following terms would best describe the temperature at which a liquid boils at a given pressure? .
- A.Degree of saturation
- B.Saturation temperature
- C.Superheated temperature
- D.Degree of superheat
-
Which one of the following is not generally recognized as one constitute of bilge water? .
- A.Oil leaking from tanks inside engine room
- B.Engine room cleaning water
- C.Water leaking from the separator sludge tank
- D.Sewage
-
When the desired rudder angle is attained by a typical double mm electro-hydraulic steering gear, the _____.
- A.ram relief valves bypass oil to stop rudder movement
- B.six-way valve shifts to the neutral flow position
- C.steering pump electric motor is de - energized by the transfer switch
- D.follow-up gear takes the hydraulic pump off stroke
-
If some surveys refer to statutory survey and ship classification survey but occur temporarily, we call them ____.
- A.periodic survey
- B.statutory survey
- C.additional survey
- D.annual survey
-
If a centrifugal pump vibrates and is noisy when operating, the cause could be _____.
- A.worn gland sealing shaft
- B.worn wearing rings
- C.a bent shaft
- D.reversed pump coupling
GMDSS题库试题(1)
GMDSS题库试题(2)
GMDSS题库试题(3)
GMDSS题库试题(4)
GMDSS题库试题(5)
GMDSS试题练习(1)
GMDSS试题练习(2)
GMDSS试题练习(3)
GMDSS试题练习(4)
GMDSS试题练习(5)