一起答
单选

Which one of the followings might not be employed to create vacuum for flash type evaporator? .

  • A.high-pressure steam-driven air-ejector
  • B.motor-driven vacuum pump
  • C.water-motivated air eductor
  • D.centrifuge pump
参考答案
查看试卷详情
相关试题
  1. Lube oil filters remove contaminants more efficiently if the oil being filtered is _____.

    • A.under high pressure
    • B.under low pressure
    • C.heated to reduce viscosity
    • D.cooled to increase viscosity
  2. The bed-plate is secured in the longitudinal direction by means of bolts known as _____.

    • A.end-chock bolts
    • B.side-chock bolts
    • C.through bolts
    • D.tie rods
  3. _____, the engine must be stopped immediately.

    • A.Should knocking occur
    • B.If knocking occur
    • C.Should if knocking occurs
    • D.If occur knocking
  4. When liquid reaches the compressor of a refrigeration system through the suction line, the condition is called _____.

    • A.flooding back
    • B.superheating
    • C.overflowing
    • D.recycling
  5. ______ means the person designated by the Company for ensuring that a ship security assessment is carried out; that a ship security plan is developed, submitted for approval, and thereafter implemented and maintained and for liaison with port facility security officers and the ship security officer.

    • A.Ship security officer
    • B.Company security officer
    • C.Port facility security officer
    • D.PSC officer
  6. Which system(s) in the hydraulic systems of crane always hold(s) single side of load?

    • A.hoisting system only
    • B.hoisting system and luffing system
    • C.hoisting system and slew and slewing system
    • D.slewing system only
  7. Which one of the followings might not be employed to create vacuum for flash type evaporator? .

    • A.high-pressure steam-driven air-ejector
    • B.motor-driven vacuum pump
    • C.water-motivated air eductor
    • D.centrifuge pump
  8. A diesel engine will lose power if fuel injection occurs too late in the cycle, because the _____.

    • A.fuel droplets will burn as they leave the fuel injector
    • B.fuel will not be properly atomized in the cylinder
    • C.maximum expansion of the burned fuel cannot take place in the cylinder
    • D.compression pressure will be too low to cause fuel ignition
  9. The heat identified by only a change in temperature is known as _____.

    • A.sensible heat
    • B.latent heat
    • C.total heat
    • D.residual heat
  10. ______ means the person designated as responsible for the development, implementation, revision and maintenance of the port facility security plan and for liaison with the ship security officers and company security officers.

    • A.Ship security officer
    • B.Company security officer
    • C.Port facility security officer
    • D.PSC officer