一起答
单选

The load limitation of governor should be reduced when ship navigating at sea, the main reason is to .

  • A.prevent the diesel engine surging
  • B.prevent governor from being damaged because of swing
  • C.reduce the probability of the crank shaft being torsional vibrated and resonated
  • D.prevent the main engine being overload or overspeed
参考答案
查看试卷详情
相关试题
  1. The effective stroke of a constant-stroke, individual, fuel injection pump is varied by the _____.

    • A.control rack
    • B.delivery valve
    • C.governor speed
    • D.plunger crossbar
  2. The steady state difference between the control point and the value of the controlled variable, corresponding with the set point, is known as __________.

    • A.dead band
    • B.control point
    • C.deviation
    • D.offset
  3. The purging of air from an elector-hydraulic steering gear unit is necessary when .

    • A.changing over to hand pump operation
    • B.engaging the trick wheel
    • C.the system has been filled with new oil
    • D.the rudder angle indicator does not match the helm position
  4. Which of the following problems can cause fluctuating pressures in the closed cooling system of a main propulsion diesel engine?

    • A.Defective temperature controls in the system
    • B.Cavitation in the cooling water pump
    • C.Opened vent in the cooling system
    • D.Restricted water passages in the engine
  5. The operation between two fuel injections is called a working cycle, which consists of a fixed sequence of eventsWhat does "which" mean in this sentence?

    • A.a working cycle
    • B.the operation
    • C.two fuel injections
    • D.events
  6. During repair, lubrication lines and orifices must be _____.

    • A.taken away
    • B.engaged
    • C.connected
    • D.sealed off
  7. Which of the following about ISM Code is not right? .

    • A.It aims to ensure safety at sea
    • B.It aims to avoid damage to the environment
    • C.It aims to prevent human injury or loss of life
    • D.It aims to provide a method to run a company
  8. In an electro-hydraulic steering system, under movement is maintained in close synchronization with the steering wheel position by means of the _____.

    • A.trick-wheel
    • B.follow-up control
    • C.six-way valve
    • D.Rapson slide
  9. In ______the control action is independent on the output.

    • A.a closed loop control system
    • B.an open loop control system
    • C.a boiler control system
    • D.a steering gear
  10. The load limitation of governor should be reduced when ship navigating at sea, the main reason is to .

    • A.prevent the diesel engine surging
    • B.prevent governor from being damaged because of swing
    • C.reduce the probability of the crank shaft being torsional vibrated and resonated
    • D.prevent the main engine being overload or overspeed